How to Install A Toilet Flange?

nstall A Toilet Flange with labels pointing to the "Wax Seal" on the floor and the "Floor Flange" to which the toilet is being connected.

Install A Toilet Flange is required to properly connect your toilet to the plumbing system. If you’re remodelling your bathroom or replacing an old flange, follow this thorough step-by-step guide:

1. Remove the old flange.

First, to Install A Toilet Flange you should shut off the water supply to the toilet. Flush to empty the tank, then use a sponge or wet/dry vacuum to get rid of any leftover water. Disconnect the water supply pipe and lift the toilet off the floor, resting it on a towel or plastic sheet. Remove the old wax ring and carefully clean the area.

2. Inspect the existing flange.

Inspect the flange for damage or corrosion. If it is in good shape, you can reuse it. Otherwise, remove it by unscrewing or cutting it off if it’s bonded to the

3. Install the New Flange

Place the new flange over the drain pipe, ensuring it sits flat on the floor. If it’s uneven, use shims to level it. For a PVC flange, apply PVC adhesive to both the inside and outside of the drain pipe. Press the flange down and hold it in place for a few minutes to allow the glue to set.

4. Attach the wax ring.

To secure the flange, centre a fresh wax ring and gently push it down. This forms a seal between the toilet and the flange, thus preventing leaks.

5. Place the Toilet

Lift the toilet carefully and place it on the flange, making sure the bolts line up with the holes in the toilet base. Lower the toilet onto the flange and firmly squeeze the wax ring.

6. Secure the toilet.

Use an adjustable wrench to uniformly tighten the bolts at the toilet’s base. Be careful not to overtighten, since this may cause the toilet foundation to break.

7. Reconnect the water supply.

Reconnect the water supply line to the toilet. Turn on the water supply and let the tank fill. Flush the toilet many times to check for leaks at the base and along the water supply line.

8. Finishing Touches

If there are no leaks, cut the bolt caps and fit them over the bolts for a neat, complete appearance.

Follow these procedures to ensure a secure and leak-free installation of your new toilet flange.

Comments are closed